Hello friends! In one of my post HOW TO CONFIGURE TELNET SERVICE IN ROUTER, I mentioned the steps on we can configure a telnet network and remote login to that but there used to be a password in that network. In my today’s post, I will tell you the ways to setup a telnet network without any password so that anyone can login to that network. So let’s get started
# take 1 router, 1 switch and 2 computers ( to make it easier to understand )
# now connect them using automatically choose connection type wire
# now click on the router > config
# go to terminal FastEthernet0/0 and give it an IP address let’s say 184.108.40.206.
# turn it on
# click on any PC > Desktop > IP Configuration
# give it an IP address let’s say 220.127.116.11
# repeat the same process in 2nd computer and give it an IP address let’s say 18.104.22.168
Now our connection is almost ready. It’s time to configure telnet service in the router.
# click on the router > cli
# and type the following codes there:-
Router(config)#line vty 0 2
Here our telnet network is ready it’s time to test it
# click on any computer > Desktop > Command Prompt
# type the following code:-
Now this time it will not ask for any password.
So this was how we can configure a telnet network without any password. If you have any doubt, advice or suggestion regarding this post then please mention it in your comments.
You may also like:-