Hello friends! In my today’s post, I will tell you how we can send/broadcast a massage to all the devices connected to a router in a network. This is a very important mean of exchange of notice or important message to all the user in a network. I will request you all to read my post HOW TO CONFIGURE TELNET SERVICE IN A ROUTER before reading this post to get it more accurately. So without wasting time let’s get started…..
# take 1 router, 1 switch and 2 computers ( to make it easier to understand)
# now connect them using automatically choose connection type wire
# click on router > config > FastEthernet0/0 and give it an IP address let’s say 220.127.116.11
# click on computer > desktop > IP Address and give it an IP address let’s say 18.104.22.168
# repeat the above step with the second computer and give it an IP address let’s say 22.214.171.124
# now configure telnet service if you don’t know how then click here
# now click on computer > command prompt
# now write telnet 126.96.36.199 and press enter, it will ask you for the password which you have given to telnet service. Input the password and press enter.
# repeat the above step with the second computer as well.
# click on the router and write the command: send * and press enter
# now write down the message let’s say hello everyone and press ctrl+z to send
# now it will confirm from you to send message or not, press y or type yes and press enter
Now go to computer > command prompt, the message you have sent will be displayed there.
So this was how we can send/broadcast a message to all the devices connected to a router in a network. If you have any doubt, suggestion or advice regarding this post then please mention it in your comments.
you may also like:-